# Fixing an uneven French tip

Learn how to fix an uneven French tip by checking smile line placement, reshaping the white edge and correcting tip alignment for a balanced, clean finish.

Fixing an uneven French tip starts with finding where the white edge sits too high, too low or tilted, then reshaping that smile line before you seal the design. The white edge of a French manicure reads as a curve across each nail, so a crooked French tip edge stands out against the nail bed. A small correction works on one nail, while a matching set needs the tip line checked against the others first. Work slowly and keep the white edge thin so a correction does not build a ridge. 

## Read the smile line before correcting 

An uneven French tip line shows best when you look at the nail straight on rather than from above. Hold the finger against a plain background and compare the white edge to the natural curve of the nail bed. Mark the high and low points of the French tip smile line with a fine brush or pencil line. This reading tells you whether the tip line needs lifting on one side or lowering on the other. 

## Reshape a crooked French tip edge 

A crooked French tip edge is corrected by removing a little white where it climbs too high and adding white where it dips. Use a small flat brush with thin white polish and paint the lower side first so the smile line meets the nail sides evenly. Let that layer dry before you extend the higher side, because wet layers blend and smear the tip line correction. Keep the white edge narrow along the free edge so the correction stays flat. 

## Match tip alignment across the set 

Tip alignment matters as much as a single nail, because one corrected tip can look wrong beside a set painted higher. Check correcting tip alignment by lining up the lowest point of every smile line at the same height on each finger. If the nails differ in length, follow the curve of each nail bed instead of forcing one shared line. Reshape the free edge first, since a slanted nail tip pushes the white line off balance. 

## Questions About Uneven French Tips 

### How do I fix an uneven French tip without removing the whole design? 

You can fix an uneven French tip by cleaning the smile line with a small brush dipped in remover and repainting only the white edge. Work on one side at a time and let each pass dry so the correction stays sharp. If the white edge is thick, thin it down before repainting, because a heavy layer hides the true curve. 

### Why does my French tip look crooked even when the white line is straight? 

A French tip can look crooked because the free edge of the nail is slanted or the nail sides are uneven. Straighten the nail shape first, then repaint the smile line to follow the corrected curve. Checking the tip against the nail bed, not the fingertip, shows where the line drifted. 

### Can I correct uneven tips with a striping brush instead of polish remover? 

A striping brush helps correct uneven tips by placing a thin white line exactly where the smile line should sit. Paint the new curve slightly below the old edge, then clean away any white outside it. This method suits a small tilt, while a large uneven tip line needs the old white removed first. 

### Which way should the French tip smile line curve when I repaint it? 

The French tip smile line curves upward at both sides of the nail and dips at the center, following the nail bed. Painting the curve in one stroke from side to side keeps it balanced. If the natural nail bed is flat, a shallow curve still reads as a clean French tip.
