# How to measure a room for flooring, carpet and wallpaper

Measure a room for flooring, carpet and wallpaper with simple steps: floor area, carpet sizing, wall area and deductions for doors, windows and repeats.

Measuring a room for flooring, carpet and wallpaper starts with the shape of the floor and the height of the walls. You take the length and width for floor area, add the extra a carpet needs at edges and pattern joins, and treat walls separately because wallpaper depends on wall height and pattern repeat. Writing every figure down as you go keeps the numbers consistent when you order materials. 

## Measure floor area first 

Floor area is the length of the room multiplied by its width, taken at the widest points. Measure along the skirting in two directions and note each figure in the same unit, then multiply them to get square footage. For an L-shaped room, split the floor into rectangles, measure each one and add the results together. A flooring calculator accepts these figures and adds a cutting allowance for the room's shape. 

## Size carpet with extra allowance 

Carpet measurement needs the room size plus an allowance for cutting, edges and pattern joins. Measure the longest and widest points of the floor, then add a margin at each edge so the fitter can trim the carpet to the wall. Patterned carpet needs extra length where the design must match across seams, and the amount depends on the size of the repeat. Give the fitter your figures and the pattern repeat so the roll is cut correctly. 

## Work out wall area for wallpaper 

Wall area comes from the perimeter of the room multiplied by wall height, with doors and windows deducted. Measure each wall from corner to corner and the wall height from floor to ceiling, then add the wall lengths together and multiply by the height. Subtract the area of doors and windows so you do not buy paper for surfaces you will not cover. Wallpaper roll coverage and the pattern repeat then show how many rolls the job needs, and a trade supplier can confirm the count. 

## Questions about measuring rooms 

### How do I measure a room for carpet? 

Measuring a room for carpet means finding the longest and widest floor measurements and adding an allowance at the edges. Draw the room shape on paper, mark where doors and alcoves fall, and record the pattern repeat if the carpet has one. A fitter uses those figures to plan seams and cutting, so give the measurements in the unit the supplier uses. 

### How do I measure a room for flooring? 

Measuring a room for flooring uses length times width at the widest points of the floor. Split any L-shape or bay into simple rectangles, measure each one, and add the areas together for total room area. Add a cutting allowance for awkward corners, and check the flooring calculator of the supplier against your own figures. 

### How do I measure a room for wallpaper? 

Measuring a room for wallpaper combines the total wall length with the wall height. Multiply the perimeter by the height, then deduct the area of doors and windows. Divide that wall area by the coverage stated on the roll and allow extra for the pattern repeat, which shifts with every drop. 

### Should I deduct doors and windows when measuring walls? 

Deducting doors and windows gives a truer wall area for wallpaper, because those surfaces take no paper. Measure each opening's height and width, multiply them, and subtract the total from the wall area. Keep a small margin in the final roll count, since trimming around frames uses more paper than the flat wall suggests.
