# Spiral and heart tie-dye patterns: how to fold and dye each shape

Learn to fold and dye a spiral and a heart tie-dye pattern on fabric, with clear steps for banding, dye placement and planning where each color lands.

A spiral and a heart are two tie-dye patterns you can build by hand, and each one comes from a different fold before any dye touches the cloth. The spiral tie-dye pattern grows from a single twisted point, while the heart tie-dye pattern comes from folding the fabric in half and drawing the heart shape with bands. This page explains how to fold each shape, where to place the dye and how to plan the colors before you start. 

## Fold and twist the spiral 

A spiral tie-dye pattern starts with the fabric laid flat and pinched at one central point. Twist that point firmly in one direction while the rest of the cloth coils around it into a flat disc. Rubber bands divide the disc into wedges, and the number of wedges sets how many color sections the spiral shows. Keep the twist tight, because a loose coil lets dye creep across the lines. 

## Crease the heart before banding 

A heart tie-dye pattern is drawn on folded fabric rather than twisted. Fold the item in half down its center, then fold again so the fold line runs through the middle of the heart you want. Trace or pin the heart outline along that fold and gather the fabric tightly along the traced line. Rubber bands placed over the gathered line hold the shape while the dye goes on either side. 

## Place dye for each shape 

Dye placement decides whether the shape reads clearly, so apply color in sections instead of pouring it over the whole bundle. On a spiral, work around the wedges in order and let each color meet the next at a band. On a heart, keep the outline area pale by leaving it undyed or by using a light tone along the banded line. Plan the colors on paper first, since what you see on the wet bundle is not the final pattern. 

## Spiral and heart tie-dye questions 

### How do I do a tie-dye tutorial heart shape step by step? 

A heart tie-dye shape comes from folding the fabric in half, drawing half a heart along the fold and gathering the fabric on that line. Rubber bands hold the gathered outline, and dye goes on the open areas on each side of the band. When you unfold the cloth, the two halves join into one heart. 

### How does a tie-dye tutorial spiral work? 

A spiral works by pinching one point of the flat fabric and twisting it until the cloth coils into a disc. Rubber bands divide the disc into pie wedges, and you dye each wedge a different color. Unfolding shows a curved spiral because the twisted fibers spring back into their flat shape. 

### Do I need rubber bands for these patterns? 

Rubber bands are the simplest way to hold both a spiral and a heart while you dye. Any tight, dye-resistant tie works, such as synthetic cord or twine, as long as it presses hard into the folds. Bands that sit loose let dye bleed under them and blur the outline of the shape. 

### How should I plan the colors for a heart or spiral? 

Color planning for a heart or spiral means choosing a light tone for the banded outline and stronger tones for the open sections. Sketch the wedges of a spiral or the inner and outer zones of a heart before you mix any dye. Dye on wet fabric spreads further than on dry fabric, so test a small scrap first.
